MessageSaver User Guide
34
Command: Q
n
Result Codes Enable/Disable
Values: n = 0 or 1
Default: 0
Description: Q0 Enables result codes.
Q1 Disables result codes.
Q2 Returns an OK for backward compatibility with some soft-
ware.
Command: S
r
=
n
Set Register Value
Values: r = S-register number; n varies
Default: None
Description: Set value of register Sr to value of n, where n is entered in deci-
mal format. E.g., S0=1.
Command: S
r
? Read Register Value
Values: r = S-register number
Default: None
Description: Read value of register Sr and display it in 3-digit decimal form.
E.g., S2? gives the response 043.
Command: T Tone Dialing
Values: P, T
Default: T
Description: Configures the modem for DTMF (touch-tone) dialing. Dialed
digits are tone dialed until a P command or dial modifier is
received.
Command: V
n
Result Code Format
Values: n = 0 or 1
Default: 1
Description: V0 Displays result codes as digits (terse response).
V1 Displays result codes as words (verbose response).
Command: W
n
Result Code Options
Values: n = 0, 1, or 2
Default: 2
Description: W0 CONNECT result code reports serial port speed, disables pro-
tocol result codes.
W1 CONNECT result code reports serial port speed, enables pro-
tocol result codes.
W2 CONNECT result code reports line speed, enables protocol re-
sult codes.
Command: X
n
Result Code Selection
Values: n = 0–7
Default: 4
Description: X0 Basic result codes (e.g., CONNECT); does not look for dial tone
or busy signal.
X1 Extended result codes (e.g., CONNECT 46000 V42bis); does not
look for dial tone or busy signal.
X2 Extended result codes with NO DIALTONE; does not look for
busy signal.