Troubleshooting / 97
Replacing a base station
To replace a base station, you do not have to power down the ICS. When you replace a base station, no portable registration information is lost. After a short boot sequence, the base station should be functioning normally.
To replace a base station, follow these steps:
1.If the base station is powered locally, unplug the power supply from the AC outlet and unplug the power supply connector from the base station
2.Remove the cover from thebase station mounting bracket.
3.If an external antenna is installed, unplug its coaxial cable from the base station.
4.Unplug the teledapt cable from the base station.
5.While holding the base station, to prevent it from falling, apply upward pressure to the base station.
6.Lift the base station away from the bracket.
7.Carefully install the new base station onto the bracket.
8.Gently press down to snap it into position.
9.Reconnect the teledapt cable to the base station connector.
10.Reconnect the power supply connector and external antenna coaxial cable to the connectors from which they were removed.
11.If the base station is powered locally, plug the power supply into the AC outlet.
The red light on each base station will flash for about 15 seconds while powering up. This is normal.
P0992639 01 | Modular ICS Companion Installer Guide |
