Installation / 21
Mount RPIs at least 300 mm (12 in.) from the ceiling.
2.Insert wall plugs in the holes.
3.Partially screw in two #10
4.Open the hinged cover with a screwdriver by pushing in and then down to release the catch on the right side. You can remove the cover by lifting it off its hinges.
Opening the RPI cover
5.Hang the RPI on the two keyhole screws and tighten them.
6.Install the remaining two screws.
7.Feed the power cord through the bottom of the RPI and route it through the clip and around the strain relief support as shown in the following figure.
8.Route the power cord to the input power socket just to the left of PSU 1. Connect the plug to the socket.
Note: Distinctive labeling of RPIs may help to diagnose any future problems.
P0992639 01 | Modular ICS Companion Installer Guide |
