Nortel Networks P0992639 01 manual Powering up the system, If display shows See

Powering up the system

If you added a base station that requires a software update, the system begins downloading the software to the base station. The Administration Terminal display shows BS-1 Dload Start. Press CLEAR to clear the message. When the base station software is downloaded, the Administration Terminal shows BS-1 Dload Done. Press CLEAR to clear the message. Some Base Stations may not be powered up at the same time, and this message repeats at the beginning of each download.

In the United States, the display shows one of the following messages after powering up:

If display shows	See
UTAM code req’d	System logical identifier (LID) on page
	66.
UTAM test failed	Alarm codes on page 102 in the
	Troubleshooting chapter.

A loss of UTAM information occurs when upgrading U.S.-based MICS-XC systems.

UTAM Recovery Codes are required.

P0992639 01 Modular ICS Companion Installer Guide