Nortel Networks P0992639 01 manual Configure base stations and portables

Programming / 71

3.Press ≠. The display reads Key 1:_.

4.Enter the 8 digit password number for Key 1. UseBKSP to make corrections. The display reads Key 2:_.

5.Enter the eight-digit password number for Key 2. Proceed as above until you have finished entering Key 3. The display reads Entry successful.

6.Repeat steps 3 through 5 for the other key.

7.Press–until the display reads Software keys or to exit.

®The system automatically starts reevaluation and the display shows Re-Eval in prog. , Re-Eval complete, System online, as the reevaluation runs its course.

Note: If the UTAM Activation Code entry is unsuccessful, the display shows Invalid code. If this happens, reenter the code or call Nortel Customer Response Center at 1-800-321-2649for assistance.

Step 5: Configure base stations and portables

Once you have entered the required keys to activate the base stations and to obtain enough portable credits, you can proceed with programming these items with the MICS-XC system.

Configure your base stations

Companion base stations are recognized by the MICS-XC system once the UTAM activation keys have been entered. To verify whether or not the base stations have been properly recognized, see Radio data on page 62 for information on the re-eval process.

P0992639 01 Modular ICS Companion Installer Guide