Programming / 55
Startup programming
Before you perform Companion programming, your system should be running and configured.
Startup programming is explained in the Modular ICS Installer Guide.
Startup erases programming.
Startup erases any existing programmed data, and resets the system to factory defaults.
Performing Startup
1.Enter the Startup access code from a M7310, M7324 or T7316 telephone dialpad, by pressing
which is the same as
••ÍÊÅÂÊË.
To be accepted, the Startup code must be entered no later than 15 minutes after the Norstar system has been powered up.
If 15 minutes have elapsed since you powered up the system, turn system power off and on, to prepare for the Startup process.
2. Enter the Installer password. The default is
P0992639 01
‡°¤‡°°‡
which is the same as
Ǥ؈ÏÈÌflfl‹››Tip - .
The Installer password shown is the default normally used for Startup. For a system which has
already been programmed, the Installer password might
have been changed in programming and recorded in the Programming Record.
