Operating Instructions
Setting | Description |
|
|
Alarm enable | Specify Alarm enable condition ([Rising : GND to Open (High)] |
condition | or [Falling : Open (High) to GND]). |
| • Specify the alarm enable condition after checking the alarm |
| specification. |
| • [Rising : GND to Open (High)] is selected automatically |
| when [Sensor] is selected. |
|
|
Before Detected/ | Specify the time before an alarm/sensor is detected or after an |
After Detected | alarm/sensor is detected. |
|
|
Executing | You can specify commands that execute for alarm detection. |
Commands for | You can configure commands in [Detection Commands] page |
Detection | (see page 33). |
|
|
Note
Configure alarm/sensor detection after an alarm/sensor has been attached to the camera.
Setting alarm/sensor detection without an alarm/sensor causes a malfunction.
32
