Setting the alarm/sensor detection method

You can set an alarm/sensor detection method for cameras that have an alarm/ sensor attached.

Alarm/sensor recording can only be enabled for cameras set to the JPEG format (see page 24).

If the camera is set to MPEG-4 format, change the setting to JPEG format, then configure the alarm/sensor.

Alarm/Sensor Page

Setting	Description

Set the Alarm1/	After you select the check box, recording will start when the
Sensor Recording / camera detects a signal.
Set the Alarm2	• If the camera is set to the MPEG-4 format (see page 24), the
Recording	following message will be displayed. Click [OK] to change to
	the JPEG format.

• Select [Sensor] for sensor supported cameras.