Operating Instructions
[About Command Execution]
If you do not select "Perform the following control when issuing a command" in "Controlling Command Execution".
(After 5 seconds from motion detection, alarm detection)
: Motion detection 
: Alarm detection
: Recording images
Execute commands for each detection.
Execute commands
When you select "Perform the following control when issuing a command" 
"Execute a command only once at the start of recording"
(After 5 seconds from motion detection, alarm detection)
Execute commands only at the start of decetion recording.
Execute commands
When you select "Perform the following control when issuing a command"
Set an interval during which to not execute commands after executing a command. (After 5 seconds from motion detection, alarm detection)
Command will not be executed if motion is detected during the specified time after detection.
specified time | specified time |
| specified time |
Execute commands
35
