Chapter 4 Settings — [PROJECTOR SETUP] menu

[COOLING CONDITION]

Change the fan control depending on the direction of projection.

Set [COOLING CONDITION] according to the projection direction, but set it to [AUTO] normally. Using the projector with incorrect setting may shorten the life of the lamp.

[VERTICAL UP SETTING]

[FLOOR SETTING]

30°

30°

[CEILING SETTING]

30°

30°

 

 

[VERTICAL DOWN SETTING]

： Projection direction

1)Press as to select [COOLING CONDITION].

2)Press the <ENTER> button.

ff The [COOLING CONDITION] screen is displayed.

3)Press as to select a cooling condition.

ff When [AUTO] is selected, the cooling conditions of [FLOOR SETTING], [CEILING SETTING], [VERTICAL UP SETTING], and [VERTICAL DOWN SETTING] are set automatically.

You can check the setting from [COOLING CONDITION] on the [STATUS] screen.

4)Press the <ENTER> button.

5)When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.

Note

ff This item cannot be set when using the optional Replacement lamp unit (for portrait mode) (Model No.: ET‑LAD320P (1 pc), ET‑LAD320PW (2 pcs)). (Setting is fixed to [PORTRAIT SETTING].)

[HIGH ALTITUDE MODE]

Set to [ON] when using the projector at high altitudes between 1 400 m (4 593') or higher and lower than 2 700 m (8 858') above sea level.

1)Press as to select [HIGH ALTITUDE MODE].

2)Press qw to switch the item.

[OFF]

When using at a location lower than 1 400 m (4 593') above sea level

[ON]

When using at high altitudes (1 400 m (4 593') or higher and lower than 2 700 m (8 858') above sea

level)

 

3)When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.

Note

ff The speed of the fan increases and the operation sound becomes louder when set to [ON].

ff This item cannot be set when using the optional Smoke cut filter (Model No.: ET‑SFD320). (Setting is fixed to [OFF].) Use it at elevations lower than 1 400 m (4 593') above sea level.

[LAMP SELECT]

Select the lamp to be turned on from the two built-in luminous lamps according to the use conditions or purposes.

1)Press as to select [LAMP SELECT].

2)Press qw to switch the item.

[DUAL]

Two lamps will light.

[SINGLE]

One lamp will light. (The lamp with shorter runtime will automatically light.)

[LAMP1]

Lamp 1 will light.

[LAMP2]

Lamp 2 will light.

ENGLISH - 109