Chapter 4Settings — [PROJECTOR SETUP] menu

Note

ff When [MODE] in [BRIGHTNESS CONTROL SETUP] is set to [AUTO] or [PC], keep the shutter open for at least two minutes to perform the brightness sensor calibration after completed the [BRIGHTNESS CONTROL SETUP] setting.

ff If the shutter is closed within approx. 10 minutes after the lamp has turned on while [MODE] in [BRIGHTNESS CONTROL SETUP] is set to [AUTO] or [PC], brightness cannot be measured. Therefore, brightness may be corrected approx. two minutes after the shutter opens.

ff When [MODE] in [BRIGHTNESS CONTROL SETUP] is set to [AUTO] or [PC], the lamp brightness is automatically measured eight minutes after the lamp is turned on, and correction is performed so that the screen brightness will be the same as the standard brightness when the brightness control is adjusted. Lamp brightness cannot be measured during the eight minutes after it is turned on because it is not steady.

ff If a lamp turns off or lamp relay is performed while [MODE] in [BRIGHTNESS CONTROL SETUP] is set to [AUTO] and [LAMP SELECT] is set to [DUAL], brightness is corrected to the extent possible one minute later.

ff When [MODE] in [BRIGHTNESS CONTROL SETUP] is set to [AUTO] and [LINK] is set to [OFF], brightness will be corrected until it reaches the maximum amount of correction.

ff The variation in brightness may increase due to dust accumulating on the lens, screen, or inside the projector, depending on the installation environment of the projector.

ff Adjust brightness control again when lamp degradation causes increased variation in brightness or a lamp is replaced.

ff For continued use longer than 24 hours, set the [BRIGHTNESS CONTROL SETUP] to [CALIBRATION TIME], or set [LAMP RELAY] (x page 110). If it is not set, correction will not be performed automatically.

ff Brightness control and iris operate simultaneously, but the iris is fully open and does not operate while a brightness measurement is performed.

ff The [CALIBRATION TIME] setting will be reflected at the time when you enter the time.

ff The [CALIBRATION MESSAGE] setting will be reflected at the time when items are switched using qw.

Displaying [BRIGHTNESS CONTROL STATUS]

Display the brightness control status.

1)Press as to select [BRIGHTNESS CONTROL].

2)Press the <ENTER> button.

ff The [BRIGHTNESS CONTROL] screen is displayed.

3)Press as to select [BRIGHTNESS CONTROL STATUS].

4)Press the <ENTER> button.

ff The [BRIGHTNESS CONTROL STATUS] screen is displayed.[BRIGHTNESS CONTROL STATUS] screen display example
When [MODE] of [BRIGHTNESS CONTROL SETUP] is set to [OFF]

The screen shows the status that the brightness control is disabled.

BRIGHTNESS CONTROL STATUS

 

MODE

OFF

PROJECTOR

1

MENU RETURN

When [MODE] of [BRIGHTNESS CONTROL SETUP] is set to [AUTO] and [LINK] is set to [OFF]

The screen shows the status of the brightness control in one projector

 

BRIGHTNESS CONTROL STATUS

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

LINK

OFF

 

5

 

 

 

PROJECTOR

 

 

 

 

1

 

 

 

 

 

 

 

6

MENU RETURN

ENGLISH - 113