Chapter 1 Preparation — About your projector

About your projector

Remote control

Front

Side

Top

1

 

 

2

 

 

3

11

20

4

 

19

 

 

 

12

 

5

 

 

6

13

 

 

14

Bottom

7

15

 

8

 

21

 

 

9

16

 

17

 

10

 

 

18

 

1Remote control indicator

Flashes if any button in the remote control is pressed.

2Power standby <v> button

Sets the projector to the state where the projector is switched off (standby mode) when the <MAIN POWER> switch on the projector is set to <ON> and in projection mode.

3Power on <b> button

Starts projection when the <MAIN POWER> switch on the projector is set to <ON> when the power is switched off (standby mode).

4Input selection (<RGB1>, <RGB2>, <DVI-D>, <VIDEO>, <HDMI>, <SDI 1/2>) buttons

Switches the input signal to project. (x page 62)

5<MENU> button/<ENTER> button/asqw buttons

Used to navigate through the menu screen. (x page 65)

6<ON SCREEN> button

Switches on (display)/off (hide) the on-screen display function. (x page 61)

7<TEST> button

Displays the test pattern. (x page 63)

8Number (<0> - <9>) buttons

Used when the system uses multiple projectors. Used to input ID numbers or passwords.

9<STATUS> button

Displays the projector information.

10<LIGHT> button

Pressing this button lights up the remote control buttons. The lights will go off when the remote control operation goes idle for

10 seconds.

11<AUTO SETUP> button

Automatically adjusts the image display position while projecting the image.

[PROGRESS] is displayed on the screen while adjusting automatically. (x page 62)

12<SHUTTER> button

Used to temporarily turn off the image. (x page 61)

13<ASPECT> button

Switches the aspect ratio of the image. (x page 63)

14Lens (<FOCUS>, <ZOOM>, <SHIFT>) buttons

Adjusts the projection lens. (x page 56)

15<FUNC> button

Assigns a frequently used operation as a shortcut button. (x page 63)

16<DEFAULT> button

Resets the content of the sub-menu to the factory default.

(x page 66)

17<ID SET> button

Sets the ID number of the remote control to use for a system using multiple projectors. (x page 28)

18<ID ALL> button

Used to simultaneously control all the projectors with one remote control for a system using multiple projectors.

(x page 28)

19<LOCK> button

Used to prevent unintended operation by careless pressing of the buttons and prevent draining the remote control batteries.

20Remote control signal transmitter21Remote control wired terminal

Connects to the projector with a cable. (x page 29)

Attention

ff Do not drop the remote control.

ff Avoid contact with liquids or moisture.

ff Do not attempt to modify or disassemble the remote control.

24 - ENGLISH