Panasonic PT-DS12KU, PT-DW11KU, PT-DZ10KU, PT-DZ13KU <REMOTE 2 IN> terminal, rrLens control command, Pin assignments and signal names, (5), (1), (9), (6), Remark, Command, Details, Open (H), Short (L)

Chapter 6 Appendix — Technical information

rrLens control command

Command	Sub command	Details	Remark
VXX	LNSI2	Lens H shift	+00000 = Fine adjustment 1+, +00001 = Fine adjustment 1-, +00100
VXX	LNSI3	Lens V shift
			= Fine adjustment 2+, +00101 = Fine adjustment 2-, +00200 = Coarse
VXX	LNSI4	Lens focus
			adjustment+, +00201 = Coarse adjustment-
VXX	LNSI5	Lens zoom

<REMOTE 2 IN> terminal

It is possible to control the projector remotely (by external contact) from a control panel located away from the projector where remote control signals cannot reach.

Use the <REMOTE 2 IN> terminal on the connecting terminals of the projector to connect to the control panel.

Remote control Contact control

Remote control/contact control

Standby Lit

Lamp

RGB1VIDEO

RGB2HDMI

	DVI-D
Installation locations in meeting rooms, etc.	Remote control board in another location

Pin assignments and signal names

D‑Sub 9-pin		Pin No.	Signal name	Open (H)	Short (L)
Outside view
		(1)	GND	―	GND
(5)	(1)	(2)	POWER	OFF	ON
		(3)	RGB1	Other	RGB1
		(4)	RGB2	Other	RGB2
		(5)	VIDEO	Other	VIDEO
		(6)	HDMI	Other	HDMI
		(7)	DVI‑D	Other	DVI‑D
(9)	(6)	(8)	SHUTTER	OFF	ON
		(9)	RST/SET	Controlled by remote	Controlled by external
				control	contact

Attention

ff When controlling, make sure to short-circuit pins (1) and (9).

ff When pins (1) and (9) are short-circuited, the following buttons on the control panel and the remote control cannot be used.

The power on <b> button, the power standby <v> button, the <SHUTTER> button, and the RS‑232C commands and network functions corresponding to these functions cannot be used either.

ff When pins (1) and (9) are short-circuited, if any pins from (3) to (7) are short-circuited with pin (1), the following buttons on the control panel and the remote control cannot be used.

The power on <b> button, the power standby <v> button, <RGB1> button, <RGB2> button, <DVI-D> button, <VIDEO> button, <HDMI> button, <SDI 1/2> button, <SHUTTER> button, and the RS‑232C commands and network functions corresponding to these functions cannot be used either.

Note

ff For pin (2) to pin (8) settings, you can make changes if you set [REMOTE2 MODE] to [USER]. (x page 120)

ENGLISH - 173