Paradyne HOTWIRE 7986 Switchpack S2 Definitions Switch # Allows you to, OFF = Autorate Disabled

Initial Startup and Configuration

Table 3-2 lists Switchpack S2 definitions.

Table 3-2. Switchpack S2 Definitions

Switch # . . .	Allows you to . . .	Default in Bold
1	Control whether the unit is an LTU or an NTU.
	OFF = NTU
	ON =LTU
2	Control enabling and disabling of the Autorate capability. Only valid for
	units configured as LTU.
	OFF = Autorate Disabled
	ON = Autorate Enabled
3, 4, 5	Select one of eight preset DSL line rates (refer to Table 3-3).
	All OFF = 2064
6, 7	Not used
8	Emergency Use Only ± The Model 7986 has two banks of flash
	memory used to hold executable firmware This switch allows you to
	switch between the two versions of firmware. This switch is
	independent from the position of Switch 1 on Switchpack S1
	(switchpack enable/disable).
	OFF = Current Firmware
	ON = Previous FW

Use Table 3-3 to set the DSL Line Rate. Defaults are shown in bold.

Table 3-3. DSL Line Rate, Switches 3 ± 5 on Switchpack S2

Switch Position
			DSL Line Rate
5	4	3
OFF	ON	ON	400 kbps
ON	OFF	OFF	528 kbps
ON	OFF	ON	784 kbps
ON	ON	OFF	1040 kbps
ON	ON	ON	1552 kbps
OFF	OFF	OFF	2064 kbps

7986-A2-GB20-00 September 1998 3-9