Configuration Option Tables
Table A-1. Network Interface Options (2 of 2)
DSL Line Rate
Possible Settings: 144, 272, 400, 528, 784, 1040, 1552, 2064
Default Setting: 2064
Specifies the DSL line rate of the unit. This option is only available when the standalone unit is configured as an LTU and AutoRate is disabled (unit is in fixed rate).
400 ± The DSL Line rate is 400.
528 ± The DSL Line rate is 528.
784 ± The DSL Line rate is 784.
1040 ± The DSL Line rate is 1040.
1552 ± The DSL Line rate is 1552.
2064 ± The DSL Line rate is 2064.
NOTE: For associated payload rates refer to Table
Peer IP Address
Possible Settings: 000.000.000.000 ± 223.255.255.255, Clear
Default Setting: 000.000.000.000
Specifies the peer IP address for the remote management providing the remote management link on the DSL loop. This option is only available when the standalone unit is configured as an LTU. The Peer IP Address is must be in the same subnet
Address Field ± (000.000.000.001 ± 223.255.255.255) ± Enter an address for the peer unit. The range for the first byte is 000 to 223, with the exception of 127. The range for the remaining three bytes is 000 to 255. The peer IP address must be in the same subnet as the MCC address.
Clear ± Clears the IP address field and sets to all zeros.
Circuit Identifier
Possible Settings: [ASCII Text], Clear
Default Setting: [blank]
Uniquely identifies the circuit number of the transmission vendor's DSL line for troubleshooting purposes.
[ASCII Text] ± Enter a maximum of 128 characters. All printable ASCII characters except ^ (caret) are allowed.
Clear ± Clears the field.
September 1998 |
