Testing

Repeater Loopback

Repeater Loopback (RLB) loops the signal being sent from the data port back to the data port and to the network interface.

CAP

CAP

E1

 

DSL

 

LIU

G.703

Port

 

Port

 

 

Transceiver

Framer

Framer

 

 

 

 

98-15999

"Procedure

To run a Repeater Loopback:

1.Position the cursor at the Start command next to Repeater Loopback on the Network Tests screen.

2.Press Enter.

The Start command is changed to Stop.

3.To manually stop the test, verify that the cursor is positioned at the Stop command.

4.Press Enter.

A Repeater loopback cannot be started when any other loopback test is in progress.

NOTE:

Activating the Repeater Loopback test causes the EOC to be lost to the remote unit.

5-4

September 1998

7986-A2-GB20-00

Page 62
Image 62
Paradyne HOTWIRE 7986 manual Repeater Loopback