Paradyne HOTWIRE 7986 manual Yyyyyyyy

Monitoring the Unit

Table 4-1. Health and Status Messages (2 of 2)

Message	What Message Indicates	What To Do
Fallback Rate,	The LTU, set to AutoRate	Reset AutoRate.
Pt 1	enable, synchronized at a	AutoRate is designed to find the
	lower rate when the line
		best rate possible for your DSL loop
	was restored after an LOS.
		conditions. After the DSL loop is up
		units should be run in fixed rate.
Primary Clock Failed	A failure has occurred in	1.	Verify that the network cable is
(G.703 Pt 1)	the primary clock source		securely attached at both ends.
	configured from the	2.	Contact network provider.
	Network, G.703, or from
	the card internal clock.
DeviceFailed	An internal error has been	1.	Provide the 8-digit failure code
yyyyyyyy	detected by the operating		shown ( yyyyyyyy ) to your service
	software. yyyyyyyy		representative.
	indicates the 8-digit	2.	Reset the Model 7976
	hexadecimal failure code.
			Standalone Termination Unit to
			clear the condition and message.
Download Failed	A firmware download was	Repeat the download.
	interrupted.
Net Com Link Down	The Network	1.	Verify that the network cable is
	communication link is		securely attached at both ends.
	down. Communications	2.	Verify the link protocol for the
	between the management
			COM port is configured correctly.
	system and the LTU/NTU
	is not possible.
Mismatch Rate, Pt 1	The LTU, in fixed rate, is	1.	Verify endpoint is not a 1 Mbps
	attempting to		product.
	communicate at a faster	2.	Upgrade remote unit to a 2 Mbps
	rate than the NTU can
			or reconfigure the LTU for fixed
	handle.
			rate at a lower rate.
NTU TS16 Not	The LTU is configured for	1.	Verify endpoint is a G.703
Supported	TS16 signaling and the		product. EIA-530A products do
	NTU is not configured to		not support signaling.
	support TS16 signaling.	2.	Replace endpoint or reconfigure
			TS16 to data.

4-4 September 1998 7986-A2-GB20-00