
Testing
DTE Loopback
DTE Loopback loops the G.703 signal back to itself before the signal is sent to the Framer.
DSL
Port All Ones
CAP | CAP |
Transceiver Framer
E1
Framer
LIU
G.703
Port
"Procedure
To run a DTE Loopback:
1.Position the cursor at the Start command next to DTE Loopback on the Network Tests screen.
2.Press Enter.
The Start command is changed to Stop.
3.To manually stop the test, verify that the cursor is positioned at the Stop command.
4.Press Enter.
A DTE Loopback cannot be started when any other loopback test is in progress.
NOTE:
Activating the DTE Loopback test causes the EOC to be lost to the remote unit.
September 1998 |