Section
20 
Audio Adjustments
2Touch ADJ. next to TIME ALIGNMENT on the sound setting menu.
# You cannot adjust the time alignment when neither FRONT LEFT nor FRONT RIGHT is se- lected in the position selector mode.
3Touch 
or 
to adjust the distance be- tween each speaker and the listening posi- tion.
Each time you touch 
or 
it increases or de- creases the distance. 0inch to 200inch is dis- played as the distance is increased or decreased.
# You can mute the selected speaker unit by touching MUTE. To cancel muting, touch MUTE again.
# You cannot select speakers whose size is set at OFF.
Note
You can store the adjusted setting in memory by using MEMORY. For details concerning opera- tion, refer to Storing the adjusted audio settings in memory on page 106.
Adjusting the speaker output levels
You can adjust the speaker output level of each speaker unit.
Recalling the speaker output level settings
%Touch SPEAKER LEVEL on the sound setting menu to select the speaker output level setting.
Touch SPEAKER LEVEL repeatedly to switch between the following speaker output level set- tings:
CUSTOM1—CUSTOM2—CUSTOM3—AUTO
#You can select LAST MEMORY only when the adjusted speaker output level setting is not mem- orized in this unit.
#You cannot select AUTO when NETWORK has been selected. (Refer to Switching the DSP setting mode on page 117.)
#When STANDARD has been selected, you cannot select AUTO if auto TA and EQ has not been carried out.
Adjusting the speaker output levels using a test tone
This function allows you to easily get the over- all balance right among the speakers.
1Recall the speaker output level settings you want to adjust.
Refer to Recalling the speaker output level set- tings on this page.
2Touch ADJ. next to SPEAKER LEVEL on the sound setting menu and then touch
TEST TONE.
The test tone is outputted. It rotates from speaker to speaker in the following sequence at intervals of about two seconds. The current settings for the speaker over which you hear the test tone are shown in the display.
Front left
Check each speaker output level. If no adjust- ments are needed, perform step 4 to stop the test tone.
# Using TEST TONE, the tweeters and the front speakers are adjusted same time. To adjust them separately, please refer to Adjusting the speaker output levels finely on the next page.
# The settings do not appear for speakers whose size is set OFF.
