
Section
20
Audio Adjustments
3Turn the ignition switch to ON or ACC. If the car’s air conditioner or heater is turned on, turn it off. Noise from the fan in the air conditioner or heater may prevent correct auto TA and EQ.
4Press SOURCE to turn the source off if this unit is turned on.
5Touch the screen to display the touch panel keys.
6Touch AV MENU and then touch
AUTO EQ&TA to enter the auto TA and EQ measurement mode.
7Touch either of the following touch panel keys to select the position for the seat on which the microphone is placed.
!FRONT LEFT – Front seat left
!FRONT RIGHT – Front seat right
8Touch NEXT.
9Plug the AUTO TA&EQ microphone into the microphone/auxiliary input jack on this unit.
11Get out of the car and close the door within 10 seconds when the
The measurement tone (noise) is outputted from the speakers, and auto TA and EQ be- gins.
# When all speakers are connected, auto TA and EQ is completed in about nine minutes.
# To stop auto TA and EQ, touch STOP.
# To cancel auto TA and EQ part way through, touch BACK or ESC.
12When auto TA and EQ is completed, Complete is displayed.
When correct measurement of car interior acoustic characteristics is not possible, an error message is displayed. (Refer to Under- standing auto TA and EQ error messages on page 127.)
13Touch ESC to cancel the auto TA and EQ mode.
14Store the microphone carefully in the glove compartment.
Store the microphone carefully in the glove compartment or any other safe place. If the microphone is subjected to direct sunlight for an extended period, high temperatures may
cause distortion, color change or mal- function.
AUTO TA&EQ microphone
10Touch START to start the auto TA and
EQ.