Pioneer Sound & Vision MIxer Video Equalizer Function, SET UP the Video EQ, Video EQ SET UP

THE VIDEO EQUALIZER FUNCTION

THE VIDEO EQUALIZER FUNCTION

Rotating the channel equalizer dial normally applies equalizer effects on audio only. However, by using the VIDEO EQ function, effects can be applied to video as well.

VIDEO EQ

HI

SET UP THE VIDEO EQ

1	Hold down the VIDEO EQ button.
	This initiates the equalizer setup mode.
2	Touch each applicable button.
	Touch each applicable button on the screen to operate the
	VIDEO EQ setup.
	• Whenever power is first turned on, default settings are as
	follows:
	HI: CONTRAST

VIDEO EQ SET UP

Use to make the video effects change simultaneously when using the equalizer.

OFF: Disables the VIDEO EQ.

R: Used when assigning parameters that change the red elements of the VIDEO EQ.

Used when assigning parameters.

G: Used when assigning parameters that change the green elements of the VIDEO EQ.

Used when assigning parameters.

B: Used when assigning parameters that change the blue elements of the VIDEO EQ.

CONTRAST: Used when assigning parameters that change the contrast of the VIDEO EQ.

HUE: Used when assigning parameters that change the hue of the VIDEO EQ.

SATURATION: Used when assigning parameters that change the saturation of the VIDEO EQ.

MID: HUE

LOW: SATURATION

Whenever power is turned OFF, the unit returns to the above status.

•Identical parameter values cannot be allocated to HI, MID and LOW.

3 Touch [EXIT].

This ends the equalizer setup mode.

TURNING THE EQUALIZER ON/OFF

1Press the VIDEO EQ button.

The VIDEO EQ settings will alternate between enabled/ disabled each time the button is pressed.

34

En