Polycom 128, 512, MP manual

Placing and Answering Calls

2.Use the arrow buttons on the remote to highlight the Speed button on the screen and change the speed of your call. Use the up and down arrow buttons to select a speed from the list that appears on screen.

3.Press the green CALL•HANG-UP button on the remote to place your call. The number and the speed that you’re dialing will appear at the top of the screen. The gray call progress indicators on the lower left side of the screen indicate that the call is going through. They will change from blue to yellow to orange, and finally green when your call goes through.

4.If the call does not complete, you will get an error message. If you receive an error, press the INFO button on the remote for an explanation.

TIP:

To view the far site again during a call, from any menu screen press the NEAR or FAR buttons on the remote.

5.When the call completes and you are using a single-monitor system, the party you called will appear on the screen and you will appear in the picture-in-picture (PIP) window at the lower right. If you have a two-monitor system, the party you are calling will appear on the main monitor and you will appear on the second monitor.

TIP:

To jump from the main calling screen to the Video Phone screen, press any digit between 0 and 9 on the numeric keypad of the remote.

6.Pan, tilt, or zoom the camera using the remote. To find out how to select the far- and near-site cameras, adjust them, and brighten or darken a room, see the Camera and Sound section of this manual.

ViewStation User’s Guide 27