Polycom® RSS™ 4000 User Guide
Parameter
Description
Using the following IP | Select this option to use the static IP address. You may | |
need to manually enter the IP address, subnet mask, and | ||
Address | ||
gateway IP address. | ||
| ||
|
| |
| Used in combination with the DHCP option. When the | |
Obtain DNS Server | Obtain an IP Address Automatically (DHCP) option is | |
Address Automatically | selected, the system will automatically obtain DNS server | |
| address from a DHCP server in the network. | |
|
| |
| If you did not select the option to automatically obtain DNS | |
Using the following | address, you must enter the preferred/alternate DNS | |
DNS Server Address | server addresses here for the system to resolve domain | |
| names. | |
|
| |
| The Network Address Translation (NAT) function of the | |
| system enables you to translate the private network IP | |
Using the following | address of packet into a public network IP address before | |
NAT Server | transmission. To enable NAT, select this check box and | |
| then enter the public network IP address to be displayed | |
| publicly. | |
|
| |
| Sets the speed/duplex modes for LAN ports. Supports the | |
| 10/100M Full Duplex or Half Duplex mode and the 1000M | |
LAN Speed | network. Select Auto to use | |
Note: When setting LAN port speed, contact your network | ||
| ||
| administrator to ensure that the switch link rate matches | |
| the system port. | |
|
|
3Click Update and a dialog box will pop up, in which you should confirm to restart the system to apply the setting.
Gatekeeper
If the system is configured to use a gatekeeper, you can use a static alias rather than an IP address that changes from day to day to perform dialing.
To configure the system to use a gatekeeper:
1Click System Config>Signaling Setting>Gatekeeper in the menu bar at the top of the page.
2Set the following parameters in the gatekeeper page:
Table
Parameter
Description
Register to Gatekeeper | Indicates whether or not to register to the gatekeeper. You | |
must check this option to set the following parameters. | ||
| ||
|
| |
| Indicates whether the system has been registered to the | |
Primary (Alternate) | primary (or alternate) gatekeeper. | |
Gatekeeper | Note: The alternate gatekeeper will only be used when the | |
| primary gatekeeper is not available. | |
|
| |
Gatekeeper IP Address | Specifies the IP address for the primary (or alternate) | |
gatekeeper. | ||
| ||
|
| |
Gatekeeper Port | Specifies the port number for the primary (or alternate) | |
gatekeeper. | ||
| ||
|
|
