Polycom ® RSS™ 4000 User Guide
1-3
Install the System
1 Place the Polycom® RSS™ 4000 unit on a stable flat surface in the
selected location.
2 Insert each power cord connector i nto the rear of the unit and c onnect
each to an appropriately r ated socket outlet. The Polyco m® RSS™ 4000
unit is supplied with two power cords, BOTH power cords should be
connected to the mains power supply during normal operation.
3 Connect the LAN cable to LAN1 in th e back of the system.
The LAN2 port is not used now and is reserv ed for future use.
4 Turn on the power switch.
Figure 1-2 Connecting Cables
Plug Acts as Disconnect Device:
•
The socket outlets to which this apparatus is connected must be installed near the
equipment and must al ways be r eadily acc essible.
• In order to fully isolate the equipment then both power co rds shoul d be
disconnected otherwise the system will remain energized.
Preparations before Configuration
Obtaini ng Network Information
Before the initial configuration, get the following information from your
network administrator to configure Polycom® RSS™ 4000 to your local
network:
• IP address, subnet mask , and default gateway IP addr ess to be assigned
to Polycom® RSS™ 4000 LAN ports.
• (Optional) Your DNS server address. The Polycom® RSS™ 4000 is
shipped with the default DNS server addresses 208.67.222.222 and
208.67.220.220 pre-configured.
• (Optional) Gatekeeper address, and the H.323 prefix and E.164 number
to be assigned to the Polycom® RSS™ 4000.
Obtaini ng the Product A ctivation Key
Before using Polycom® RSS ™ 4000, you need to activate the dev ice. Follow
the procedure below to obtain th e product activation key. When you power
on and log in to the Polycom® RSS™ 4000 for the first time, the system