Q-Logic 5202, 5200 manual Topology, Displays all connected devices, Users, Version

0			A – Command Line Interface
			Show Command
	Table A-16. Switch Operational Parameters (Continued)
	Parameter		Description
	LogLevel	Event severity level used to record
		events in the event log
	MaxPorts	Number of ports available on the switch
	NumberOfResets	Number of times the switch has been
		reset over its service life
	ReasonForLastReset	Action that caused the last reset
	ActiveImageVersion - build date	Active firmware image version and build
		date.
	PendingImageVersion - build date	Firmware image version and build date
		that is pending. This image will become
		active at the next reset or power cycle.
	ActiveConfiguration	Name of the switch configuration that is
		in use.
	AdminState	Switch administrative state
	AdminModeActive	Admin session status
	BeaconOnStatus	Beacon status as set by the Set Beacon
		command.
	OperationalState	Switch operational state
	PrincipalSwitchRole	Principal switch status. True indicates
		that this switch is the principal switch.
	BoardTemp (1) - Degrees Celsius	Internal switch temperature at circuit
		board sensor 1
	SwitchDiagnosticsStatus	Results of the power-on self test
	SwitchTemperatureStatus	Switch temperature status: normal,
		warning, failure

topology

Displays all connected devices.

users

Displays a list of logged-in users. This is equivalent to the User List command.

version

Displays an introductory set of information about operational attributes of the switch. This keyword is equivalent to the About keyword.

59056-02 A A-67