0  | 
  | 
  | A – Command Line Interface  | 
  | 
  | 
  | |
  | 
  | 
  | Set Setup Command  | 
  | 
  | 
  | 
  | 
  | 
  | 
  | 
  | 
  | Table  | ||
  | 
  | 
  | |
  | Entry | Description  | |
  | 
  | 
  | |
  | ReadCommunity  | Read community password that authorizes an SNMP agent  | |
  | 
  | to read information from the switch. This is a   | |
  | 
  | The value on the switch and the SNMP management server  | |
  | 
  | must be the same. The read community password can be up  | |
  | 
  | to 32 characters excluding #, semicolon (;), and comma (,).  | |
  | 
  | The default is “public”.  | |
  | WriteCommunity  | Write community password that authorizes an SNMP agent  | |
  | 
  | to write information to the switch. This is a   | |
  | 
  | The value on the switch and the SNMP management server  | |
  | 
  | must be the same. The write community password can be  | |
  | 
  | up to 32 characters excluding #, semicolon (;), and comma  | |
  | 
  | (,). The default is “private”.  | |
  | TrapCommunity  | Trap community password that authorizes an SNMP agent  | |
  | 
  | to receive traps. This is a   | |
  | 
  | switch and the SNMP management server must be the  | |
  | 
  | same. The trap community password can be up to 32  | |
  | 
  | characters excluding #, semicolon (;), and comma (,). The  | |
  | 
  | default is “public”.  | |
  | AuthFailureTrap  | Enables (True) or disables (False) the generation of traps in  | |
  | 
  | response to trap authentication failures. The default is False.  | |
  | ProxyEnabled  | Enables (True) or disables (False) SNMP communication  | |
  | 
  | with other switches in the fabric. The default is True.  | |
  | 
  | 
  | 
  | 
system
Prompts you in a 
Note: Changing the IP address will terminate all Ethernet management sessions.
Table A-14.  System Configuration Settings
Entry | Description  | 
  | 
  | 
Eth0NetworkDiscovery  | Ethernet boot method: 1 - Static, 2 - Bootp, 3 -  | 
  | DHCP, 4 - RARP. The default is 1 - Static.  | 
Eth0NetworkAddress  | Ethernet Internet Protocol (IP) address. The  | 
  | default is 10.0.0.1.  | 
  | 
  |