Pkg Freq

This sets the reference frequency for the filter used in adjusting the specific range of frequencies.

When not cutting bass frequencies, set this to BYPASS.

Pkg Q

The range of frequencies is based on the frequency set in Pkg Freq.

The smaller the value, the narrower the band of frequencies that is adjusted with Pkg Gain.

Pkg Gain

This sets the gain (boost or cut) of the range of frequencies set in Pkg Freq and Pkg Q.

LF Damp

This sets the reference frequency used in cutting the resonance sound's low-end component.

When not cutting these sounds, set this to BYPASS.

HF Damp

This sets the reference frequency used in cutting the resonance sound's high-end component.

When not cutting these sounds, set this to BYPASS.

Diffusion

Adjusts the change in the density of the resonance over time.

65: ODROTARY (OverdriveRotary)

This effect connects an overdrive and a rotary in series.

Drive

Adjust the degree of distortion. The volume will change together with the degree of distortion.

OD OutLvl (Overdrive Level)

Sets the Overdrive output level.

OD Sw (Overdrive Switch)

Switches the Overdrive on and off.

Low Slow (Low Frequency Slow Rate)

Adjust the slow speed (SLOW) of the low frequency rotor.

Low Fast (Low Frequency Fast Rate)

Adjust the fast speed (FAST) of the low frequency rotor.

Low Accel (Low Frequency Acceleration)

Adjust the time it takes the low frequency rotor to reach the newly selected speed when switching from fast to slow (or slow to fast) speed. Lower values will require longer times.

Low Level (Low Frequency Level)

Adjust the volume of the low frequency rotor.

Hi Slow (High Frequency Slow Rate)

Adjust the slow speed (SLOW) of the high frequency rotor.

Hi Fast (High Frequency Fast Rate)

Adjust the fast speed (FAST) of the high frequency rotor.

Hi Accel (High Frequency Acceleration)

Adjust the time it takes the high frequency rotor to reach the newly selected speed when switching from fast to slow (or slow to fast) speed. Lower values will require longer times.

Effect/Parameter List

Hi Level (High Frequency Level)

Adjust the volume of the high frequency rotor.

Separate (Separation)

Adjust the spatial dispersion of the sound.

Speed #

Simultaneously switch the rotational speed of the low frequency rotor and high frequency rotor.

SLOW: Slow down the rotation to the specified speed (the Low Slow/Hi Slow values).

FAST: Speed up the rotation to the specified speed (the Low Fast/Hi Fast values).

Level (Output Level) #

Adjust the output level.

When Using 3D Effects

The following three 3D effects utilize RSS (Roland Sound Space) technology to create a spaciousness that cannot be produced by delay, reverb, chorus, etc.

48:3D DELAY

60:3D CHORUS

61:3D FLANGER

When using these effects, we recommend that you place your speakers as follows. Also, make sure that the speakers are at a sufficient distance from the walls on either side.

fig.RSS

30˚ 30˚

If the left and right speakers are too far apart, or if there is too much reverberation, the full 3D effect may not appear. Each of these effects has an Out (Output Mode) parameter. If the sound from the OUTPUT jacks is to be heard through speakers, set this parameter to SPEAKER. If the sound is to be heard through headphones, set it to PHONES. This will ensure that the optimal 3D effect will be heard. If this parameter is not set correctly, the full 3D effect may not appear.

Appendices

125

Page 125
Image 125
Roland RD-700 owner manual 125, 65 OD→ROTARY Overdrive→Rotary