Roland RD-700 owner manual Detailed Settings for Transmitted Parts Midi TX, How to Make Settings

Using the RD-700
As a Master
Keyboard	Using the RD-700 As a Master Keyboard

Detailed Settings for Transmitted Parts ([MIDI TX])

After pressing [MIDI TX], you can then set the following parameters affecting MIDI TX parts.

fig.LCD

How to Make Settings

1.Press [MIDI TX], getting the indicator to light.

The RD-700 is set to control the external MIDI devices.

2.Press CURSOR [ ], [ ], [ ], or [ ] to move the cursor to the parameter to be set.

You can get the cursor to move more rapidly by holding down the CURSOR button that points in the direction you want the cursor to move while you also press the CURSOR button that points in the opposite direction.

3.Press [INC/YES] or [DEC/NO] to set the value. Press [INC/YES] and [DEC/NO] simultaneously to switch the Value to “--- (OFF).”

Adjusting the Volume and Pan

Sets the panning (localizes sound image) for each of the Tones.

The Volume setting is mainly used in the Split and Layer key modes to obtain the desired balance in volume between each part.

The Pan setting positions the sound image of each part when the output is in stereo. With an increase in the value for L, more of the sound will be heard as coming from the left side. Similarly, more of the sound will originate at the right if the value of R is increased. When set to 0, the sound is heard as coming from the center.

Parameter	TX CC#	Value
VOL (Volume)	CC07	0-127
PAN (Pan)	CC10	L63–0–63R

Setting the Amount of Reverb and Chorus

This sets the depth of the reverb and chorus effects.

Parameter	TX CC#	Value
REV (Reverb)	CC93	0–127
CHO (Chorus)	CC91	0–127

Setting the Key Range (LWR/UPR)

Set the keyboard range in which each Part will sound. This can be used to make notes in different areas of the keyboard play different Tones.

Specify the lower limit (LWR) and upper limit (UPR) of the key range being set.

Parameter	Value
LWR (Lower)	A0–C8
UPR (Upper)	A0–C8

NOTE

This is effective only when [SPLIT] is on (p. 43) in the key range settings.

NOTE

You cannot set the key range’s lower limit higher than the upper limit, nor can you set the upper limit below the lower limit.

You can use PART SWITCH for each individual part to select whether or not MIDI Note messages for that part are to be

Master Keyboard

63