Roland RD-700 owner manual 121, Stereo Compressor, Stereo Limiter

Mic Set (Mic Setting)

Adjust the location of the mic that is recording the sound of the speaker. This can be adjusted in three steps, with the mic becoming more distant in the order of 1, 2, and 3.

Mic Lvl (Mic Level) #

Adjust the volume of the microphone.

Dir Lvl (Direct Level) #

Adjust the volume of the direct sound.

Level (Output Level) #

Adjust the output level.

53: OVERDRIVE 2

This is an overdrive that provides heavy distortion.

Drive #

Adjust the amount of distortion. The volume will change together with the degree of distortion.

Level (Output Level)

Adjust the output level.

Low Gain

Adjust the low frequency gain (amount of boost or cut). Positive (+) settings will emphasize (boost) the low frequency range.

High Gain

Adjust the high frequency gain (amount of boost or cut). Positive (+) settings will emphasize (boost) the high frequency range.

Amp Sw (Amp Simulator Switch)

Turns the Amp Simulator on/off.

Amp Type (Amp Simulator Type)

Adjust the type of guitar amp.

SMALL: small amp

BUILT-IN: single-unit type amp

2-STACK: large double stack amp

3-STACK: large triple stack amp

Tone

Adjust the sound quality of the Overdrive effect.

Pan (Output Pan) #

Adjust the stereo location of the output sound. A setting of L64 is far left, 0 is center, and 63R is far right.

54: DISTORTION 2

This is a distortion effect that provides heavy distortion.

Drive #

Adjust the amount of distortion. The volume will change together with the degree of distortion.

Level (Output Level)

Adjust the output level.

Low Gain

Adjust the low frequency gain (amount of boost or cut). Positive (+) settings will emphasize (boost) the low frequency range.

Effect/Parameter List

High Gain

Adjust the high frequency gain (amount of boost or cut). Positive (+) settings will emphasize (boost) the high frequency range.

Amp Sw (Amp Simulator Switch)

Turns the Amp Simulator on/off.

Amp Type (Amp Simulator Type)

Adjust the type of guitar amp.

SMALL: small amp

BUILT-IN: single-unit type amp

2-STACK: large double stack amp

3-STACK: large triple stack amp

Tone

Adjust the sound quality of the Overdrive effect.

Pan (Output Pan) #

Adjust the stereo location of the output sound. A setting of L64 is far left, 0 is center, and 63R is far right.

55: STEREO COMPRESSOR

Sustain

Adjust the time over which low level sounds are boosted until they reach the specified volume.

Attack (Attack Time)

Adjust the attack time of an input sound.

Post Gain

Adjust the output gain.

Low Gain

Adjust the low frequency gain.

Positive (+) settings will emphasize (boost) the low frequency range.

High Gain

Adjust the high frequency gain.

Positive (+) settings will emphasize (boost) the high frequency range.

Level (Output Level) #

Adjust the output level.

56: STEREO LIMITER

Threshold (Threshold Level)

Adjust the volume at which compression will begin.

Release (Release Time)

Adjust the time from when the volume falls below the Threshold Level until compression is no longer applied.

Ratio (Compression Ratio)

Adjust the compression ratio.

Post Gain

Adjust the output gain.

Low Gain

Adjust the low frequency gain.

Positive (+) settings will emphasize (boost) the low frequency range.

Appendices

121