Roland RD-700 owner manual Number Device ID p

Detailed Settings for Each Function ([EDIT])

Bulk Dump SETUP				Restoring saved settings to the RD-700
6	Press CURSOR [	].		When returning settings saved to an external sequencer back
				to the RD-700, an Exclusive message is transmitted from the
	A screen like the one shown below appears.
				external sequencer, then the data is received by the RD-700.
				NOTE
				Be aware that when you restore SETUPs data to the RD-700,
				the data in the RD-700 will be overwritten and lost.
				1. Use a MIDI cable to connect the MIDI OUT connector of
					the external sequencer to the MIDI IN connector of the
	Parameter		Value		RD-700.
				2. Set the device ID number to the same setting as when
From		Setup number for the first Setup to
					you performed the bulk dump.
		be transmitted.
To		Setup number for the last Setup to be
		transmitted.
				Setting the Device ID Number ➔ “Setting the Device ID
		Determines whether the system set-		Number (Device ID)” (p. 71)
Send System		tings are to be transmitted (YES), or		3. Make sure that [EDIT] indicator is extinguished.
		not (NO).			If the [EDIT] indicator is lit, press [EDIT] to turn the
					indicator light off and put the RD-700 in normal
7.	Press CURSOR [	] / [	] and [INC/YES]/[DEC/
					performance mode.
	NO] to set the transmitted SETUPs.			4. Transmit (play back) the data from the external
8.	Press CURSOR [	].			sequencer.
				5. After the transmitting is finished, the display will
	A screen like the one shown below appears.
					indicate “COMPLETED.”
fig.Editmenu2.eps_150
				NOTE
				After playback of the Bulk Dump SETUP data, the RD-700
				writes the data to the internal memory. Be sure never to turn
				off the power while this data is being written (while “Now,
9. Put the external sequencer in record mode.				writing Bulk Dump Data. Keep on POWER!” is showing).
10. Press [INC/YES] to transmit the settings.
	To cancel the Bulk Dump, press [DEC/NO].			For details on transmitting exclusive data, refer to the
				owner’s manual for your sequencer.
	A screen like the one shown below appears.
fig.Editmenu2.eps_150				NOTE
				Play back the external sequencer at the same tempo you used
				when performing the bulk dump. If you use a faster tempo,
				the data may not be restored correctly.

NOTE

11.After the transmitting is finished, the display will

indicate “COMPLETED.”	Data cannot be received if the Device ID of the receiving
	device differs from the Device ID used when Bulk Dump was
You are returned to the Edit screen.
	carried out.
12. Stop the external sequencer.	NOTE
	Exclusive messages cannot be received when set to GM
	Mode (p. 98). Carry out the operation after first exiting GM
	Mode.

Edit Mode

93