Sharp AR-M208 Power On And Off, Power on, Power off, Dehumidification heater switch DH POWER

Models: AR-M208

1 128
Download 128 pages 42.34 Kb
Page 18
Image 18
POWER ON AND OFF

POWER ON AND OFF

The power switch is located on the left side of the copier.

Power on

Turn the power switch to the "ON" position.

GETTING STARTED

Power on

Power off

When the power switch is turned to the "ON" position, the message "System check." will appear in the message display and warm-up will start. During warm-up, you can select your desired job settings

and then by pressing the START (Power on) key, your job will commence when the copier comes to "Ready to copy.". Once the copier has finished warming up, the message display will change to "Ready to copy.", and the START (Power off) key indicator will light up, indicating that copying is possible.

If the copier has been programmed in the auditing mode, the message "Enter your account number." will appear after warming up. Once a valid account number has been entered, the message display will change to "Ready to copy." and copying will be possible. See page 20.

Power off

When the copier is not used for a long time, be sure to turn it off.

Ensure that the machine is not operating and then turn the power switch to the "OFF" position. If the power switch is turned off while the machine is operating, a misfeed may occur. Also the job that was in progress will be totally canceled.

Dehumidification heater switch (DH POWER)

This copier is equipped with a dehumidification heater, which prevents dew condensation inside the copier and moisture absorption of paper in the paper trays. If dew condensation occurs and causes moisture absorption of paper, image quality may be deteriorated and paper misfeeds may occur frequently. It is recommended that the dehumidification heater switch be left in the “ON” position in the following cases even after the power switch is turned off.

In a low temperature season such as winter (When a sudden temperature change occurs, for example, immediately after room heating is turned on, dew condensation may occur.)

In a high temperature and high humidity season such as summer or rainy season

In regions at a high temperature and a high humidity

On

NOTES:

When using the dehumidification heater, do not remove the power cord from the outlet. Doing so will stop the heater.

If an optional 500-sheet paper feed unit or 2x500-sheet paper feed unit is installed, the heater in the unit will also be turned on when the dehumidification heater switch of the copier is turned on.

16

Page 18
Image 18
Sharp AR-M208 operation manual Power On And Off, Power on, Power off, Dehumidification heater switch DH POWER