
MAKING COPIES
COPYING FROM THE RSPF
About reversing single pass feeder (RSPF)
The reversing single pass feeder (RSPF) hold up to 40 originals each for automatic document feeding. If the RSPF is being used,
Acceptable originals
Up to 40 originals ranging from
NOTES:
●Be sure to remove any staples or paper clips from the originals.
●Before placing curled or wavy originals into the document feeder tray, be sure to flatten them. If not, original misfeeds may result.
●For best feeding of originals which have binding holes punched into them, insert them so that the holes are positioned to the right or along the original guides. In this case the settings for margin shift may need to be changed. See page 51.
Unacceptable originals
The following types of paper cannot be used as originals:
●Special papers including transparency film, photographs, and tracing paper
●Damaged or crumpled originals
●Paper with multiple punched holes (paper with two or three holes can be used)
●
Stream feeding mode
If the stream feeding mode has been enabled using a key operator program, the message "Set originals for stream feeding." will appear for approximately 5 seconds after feeding of all originals is completed. While this message is displayed, any new originals placed in the RSPF will be fed and copied automatically.
★KEY OPERATOR See page 10 of the KEY OPERATOR'S GUIDE for information on setting the stream feeding mode.
Using the RSPF
1 | Ensure that no original is left on the platen glass. | ||
2 | Adjust the original guides to the size of the originals. | ||
|
|
|
|
|
|
|
|
26