Maintenance and service
12.4 Installing and removing hardware components
Inserting the slider
To insert the slider:
How to install a module holding-down device
1
Push the slider through the guide slot until it is seated firmly on the module. Insert the module into the slot.
Caution
Do not apply any pressure to the module Therefore, do not apply excessive force to the slider when you push it onto the module.
2
Cut off the rest of the slider: Use a knife to notch the slider at the upper edge of the bracket and then break this section off. Cut off the residual element using a sharp side cutter.
SIMATIC Panel PC 877 | |
Operating instructions, Release 07/2006, |
