Operation and configuration

9

9.1Normal operation

9.1.1Switch on the device

Requirements

The peripheral devices are connected.

Caution

To comply with the EMC guideline of the device with I/O, ensure that the manufacturer or supplier of the components used guarantees compliance with the regulations. Connect the I/O devices via shielded cables with metal connectors. In doing so, the shield must be connected over a wide area with the metal connector and the connector must be firmly connected with the device housing.

The operating system and the service packs have been installed and set up on the hard disk of the device. Refer to the "Commissioning" chapter for more information.

The pre-installed drivers and applications have been set up appropriately. Further information is available in the "Operation and configuration" chapter in the section, "Additional drivers and applications."

The proper ambient and environmental conditions according to the specifications for the device and the connected I/O modules have been observed.

SIMATIC Panel PC 877

9-1

Operating instructions, Release 07/2006, A5E00877780-01

Page 69
Image 69
Siemens PANEL PC 877 operating instructions Operation and configuration, Normal operation, Switch on the device