Alarm, error and system messages | 13 |
13.1Boot error messages
During startup (the boot process), the BIOS first performs a Power On Self Test (POST) and checks whether certain functional units of the PC are operating
If the POST does not return an error, the BIOS initializes and tests further functional units. In this startup phase, the graphics controller is initialized and any error messages are output to the screen.
The following lists the error messages from the system BIOS. For information on error messages output by the operating system or programs, refer to the corresponding manuals.
On-screen error messages
| Meaning / suggestions |
Address conflict | Plug and Play problem. |
| Contact your technical support team. |
Combination not supported | Plug and Play problem. |
| Contact your technical support team. |
IO device IRQ conflict | Plug and Play problem. |
| Contact your technical support team. |
Invalid System Configuration | Plug and Play Problem |
Data | • Set the RESET CONFIGURATION DATA option in the |
| "Advanced" menu of Setup. |
| • Contact your technical support team. |
Allocation Error for ... | Plug and Play problem |
| • Please undo the last hardware change. |
| • Contact your technical support team. |
System battery is dead. | The battery on the CPU module is defective or dead. |
Replace and run SETUP | Contact your technical support team. |
System CMOS checksum bad | Call up SETUP, adjust settings and save. If this message appears |
Run SETUP | during each startup, contact your technical support team. |
Failure Fixed Disk | Error accessing the hard drive. |
| Check the SETUP settings. |
| Contact your technical support team. |
SIMATIC Panel PC 877 | |
Operating instructions, Release 07/2006, |