TDK 750W HALF RACK technical manual 110x

Print Power On	Byte 1	Power On	Read the time the supply is active
Time	1010 0110	time in min-	under AC Power. xxxx xxxx is the
	Byte 2	utes	address of the supply in binary.
	xxxx xxxx		Returns a 32 Bit integer as 8 Hex
			bytes. A ‘$’ sign is appended to
			the data followed by a 2 byte
			check-sum. A total of 11 bytes are
			returned.
Retransmit last	110x xxxx	Last message	Retransmit last response from a
message			command. x xxxx is the address of
			the supply in binary.
Acknowledge	111x xxxx	None	Acknowledge SRQ. If retransmis-
SRQ			sion of SRQ is enabled, it will re-
			main enabled for the next SRQ. X
			xxxx is the address of the supply
			in binary.
Test if MD Mode	Byte 1	0 or 1	Returns a 0 if not installed or a 1 if
is Installed	1010 1010		installed. A ‘$’ sign followed by a 2
	Byte 2		bytes checksum and Carriage Re-
	xxxx xxxx		turn is appended to the data. xxxx
			xxxx is the address of the supply
			in binary.
Supply Initiated
Communications
SRQ	100x xxxx	N/A	SRQ from supply when in MD
			Mode. X xxxx is the address of the
			supply in binary.
	Table 7-4. SINGLE BYTE COMMUNICATIONS

GEN750W models

Table 7-5: Current programming range

Model	Minimum	Maximum
	(A)	(A)
GEN6-100	000.00	100.00
GEN8-90	00.00	90.00
GEN12.5-60	00.000	60.000
GEN20-38	00.000	38.000
GEN30-25	00.000	25.000
GEN40-19	00.000	19.000
GEN60-12.5	00.000	12.500
GEN80-9.5	0.000	9.500
GEN100-7.5	0.000	7.500
GEN150-5	0.000	5.000
GEN300-2.5	0.000	2.500
GEN600-1.3	0.000	1.300

NOTE:

The power supply can accept values 5% higher than the table values, however it is not recommended to program the power supply over the rated values.

62

83-507-5002 Rev. B