Tektronix 340 manual Replace Maintenance Tray

4Caring for Your Printer

2.When you open the front cover, the following message appears:

Caution Hot Surfaces

Replace Maintenance Tray

3.Grasp the maintenance tray by the front edge and lift up while sliding it out of the printer.

9101-53

Note Once the maintenance tray has been partially used, it leaks drum fluid if tipped. Never ship a partially used maintenance tray. Contact with the drum fluid poses no known health risk. Refer to “MSDS for silicone oil” on page D-7 for more information.

4.Install a new maintenance tray in the printer.

Note Be sure to push on both sides of the maintenance tray to latch it firmly into the printer.

5.Close the front cover and wait for the printer to warm-up.

6.To prevent leaking, seal the used maintenance tray in the plastic bag from the new (replacement) maintenance tray. Treat the used maintenance tray as normal office waste.

4-8 Phaser 340 Color Printer