4 Replacement Procedures

4.13 Parallel port board / Serial port board / S-Video board

4.13.3 S-Video board

Removing the S-Video board

The following describes the procedure for removing the S-Video board (See Figure 4-27, 4- 30).

NOTE: The procedure 1 and 2 are the same items as parallel port board. Refer to the figure 4-27 in the parallel port board.

1.Remove the DC-IN jack and core from the slot of the base assembly.

2.Remove the following screws to remove the harness holder.

• M2.5x4B THIN BIND screw

x2

3.Disconnect the USB harness from the connector PJ4610 and the S-Video harness from the connector PJ5640 on the S-Video board.

4.Remove the S-Video board by lifting it

S-Video board

USB harness

PJ4610 PJ5640

S-Video harness

Figure 4-30 Removing S-Video board

4-44

[CONFIDENTIAL]

Satellite A50S/TECRA A3X Maintenance Manual (960-534)

Page 266
Image 266
Toshiba A3X manual Video board Removing the S-Video board, Removing S-Video board