4.11 Display Assembly

4 Replacement Procedures

Installing the Display assembly

The following describes the procedure for installing the display assembly (See Figure 4-23 to 4-25).

1.Pass the wireless LAN antenna cables through the slot near the center of the base assembly.

2.Install the display assembly on the base assembly from the rear of the computer and secure them with the following screws.

M2x8B

BIND screw

x1

M2.5x8B

THIN BIND screw

x1

3.Connect the LCD harness to the connector CN5000 on the system board and install the LCD harness hold plate with the following screw.

• M2.5x8B

THIN BIND screw x1

4.Connect the speaker cables (blue, red) to the connectors CN6001, CN6002 on the system board.

5.Connect the touch pad cable to the connector CN3240 on the system board.

6.Close the display and turn the computer face down. Secure the base assembly with the following screws from the bottom.

M2.5x6B

THIN BIND screw

x9

(“6” in the figure)

M2.5x14B

THIN BIND screw

x5

(“14” in the figure)

M2.5x18B

THIN BIND screw

x1

(“18” in the figure)

Satellite A50S/TECRA A3X Maintenance Manual (960-534)

[CONFIDENTIAL]

4-37

Page 259
Image 259
Toshiba A3X manual Installing the Display assembly