2.4GHz 150Mbps Outdoor Wireless Access Point User Guide
1.4.2The Rear Panel
Figure 1-2 Rear Panel sketch
View from left to right, the parts are explained below.
: This is where you can connect an outside antenna. For this AP, the antenna is built inside, and usually there is not necessary to connect an outside one.
LAN: This port is used to connect to the POE port of the provided Power Injector.
RESET:
There are two ways to reset the AP's factory defaults:
•Use the Factory Defaults function on System Tools
•Use the Factory Default Reset button: Press and hold the RESET button for at least 5 seconds, and then the AP reboots after the LED at the rightmost in Figure
Note:
Ensure the AP is powered on before it restarts completely.
5
