Xantrex Technology XMP 2600 manual Commands and Queries Reference, Alphabetical reference

Alphabetical reference		Commands and Queries Reference
SHUT	defines the optional events that will cause a single, group or global
	shutdown.
	Syntax	SHUT <int>
	Parameters	the integer is a value in the range 0 to 7, derived
		from summing the following event category
		selections:
		1 – errors reported by	the Power Module (not
		including error codes 7 and 8).
		2 – sense warning.
		4 – window warning.
	Category	System	Type: Sequential
SHUT?	returns the	current selection of non-fault events that will cause a
	single, group or global shutdown. The returned value (in the range 0 to

7)is a sum of individual events categories selections (see SHUT command above).

Syntax	SHUT?
Parameters	none
Category	System	Type: Sequential

When the Power Supply is turned on or a full reset is performed, the selection of non-fault events that will cause a single or global shutdown is cleared.

SN?	return the Power Module’s Serial Number. The result is a six digit
	number.
	Syntax	SN? <ch>
	Parameters	the number of the channel to be queried.
	Category	System	Type: Sequential
SRQS?	return the	Power Modules Summary Register. The result is two
	decimal numbers. Each bit of the reply represents a channel. A bit
	value of “0” means that the Power Module has no enabled status
	events. A bit value of “1” means that it has. The reply is a 16-bit value
	with its high order byte sent first. The summary bits are cleared and
	<rqs> re-calculated.
	Syntax	SRQS?
	Parameters	none
	Category	Status	Type: Sequential

60 XMP 2600 Programming Manual rev. 1.1