Xantrex Technology XMP 2600 manual Commands and Queries Reference, Alphabetical reference

Commands and Queries Reference			Alphabetical reference
PROT	set-up the Protection Mode of the Power Module.
	Syntax	PROT <ch>,<int>
	Parameters	the number of the Power Module to be programmed.
		the desired Protection Mode: a value of “0” means
		Manual Protection Mode - in this mode the OVP and
		OCP thresholds are programmed by the user. A
		value of “1” means Automatic Protection Mode - the
		OVP and OCP thresholds are set, automatically, by
		the XMP 2600 as 10% to 20% above the SET
		values. If changing from Manual to Automatic mode
		then new OVP and OCP thresholds are calculated.
	Category	Protection	Type: Overlapped
PROT?	return the current Protection Mode of the XMP 2600.
	Syntax	PROT? <ch>
	Parameters	the number of the channel to be queried.
	Category	Protection	Type: Sequential
PSR?	return the value of the Primary Status Register. The value returned is a
	decimal number in the range 0 to 255 representing the bits of the
	Register.
	Syntax	PSR?
	Parameters	none
	Category	Status	Type: Sequential
PWR?	return the value of the Power Warning Threshold of the XMP 2600
	master mainframe. For the XMP 2600 this value is 2400.
	Syntax	PWR?
	Parameters	none
	Category	System	Type: Sequential
RAMP	program the Power Module’s Ramp Duration.
	Syntax	RAMP <ch>,<ramp_duration>
	Parameters	the number of the Power Module to be programmed.
		the Ramp Duration in units of mili-seconds. The
		XMP 2600 Ramp Duration resolution is 6mS, so the
		programmed value will be set internally to a
		multiplication of 6. The general format for the Ramp
		Duration is: sss:nnn	where sss=seconds and
		nnn=mili-seconds. The maximal duration is 393:210.
		Duration can be programmed in units of mili-
		seconds (e.g. “4032” = 004:032) or seconds (e.g.
		“100:” = 140:000).
	Category	Settings	Type: Sequential

XMP 2600 Programming Manual rev. 1.1 57