Commands and Queries Reference |
| Alphabetical reference | |
OVSET? | return the current programmed value of the Power Module’s OVP | ||
| threshold. The result is a <value>. |
| |
| Syntax: | OVSET? <ch> |
|
| Parameters | the number of the channel to be queried. | |
| Category | Protection | Type: Sequential |
PEE | assign new value to the Primary Event Status Enable Register. Re- | ||
| calculates <rqs> and <ist>. |
| |
| Syntax | PEE <int> |
|
| Parameters | the value to be assigned to the Register - a decimal | |
|
| number in the range 0 to 255 representing bits in the | |
|
| Register. |
|
| Category | Status | Type: Sequential |
PEE? | return the value of the Primary Event Status Enable Register. The | ||
| value returned is a decimal number in the range 0 to 255 representing | ||
| the bits of the Register. |
| |
| Syntax | PEE? |
|
| Parameters | none |
|
| Category | Status | Type: Sequential |
PER? | return the value | of the Primary Event Status Register. The value | |
| returned is a decimal number in the range 0 to 255 representing the | ||
| bits of the Register. The register is cleared. | ||
| Syntax | PER? |
|
| Parameters | none |
|
| Category | Status | Type: Sequential |
POL | change the Power Module’s output polarity. This command requires | ||
| the presence of the Polarity Reversal Relay Option. | ||
| Syntax | POL <ch>,<int> |
|
| Parameters | the number of the Power Module to be operated | |
|
| upon. |
|
|
| the desired state of the Power Module’s output | |
|
| polarity: a value of “0” means positive and a value | |
|
| of “1” means negative output polarity. | |
| Category | Output | Type: Overlapped |
POL? | return the current output polarity of the Power Module. | ||
| Syntax | POL? <ch> |
|
| Parameters | the number of the channel to be queried. | |
| Category | Output | Type: Sequential |
XMP 2600 Programming Manual rev. 1.1 | 55 |
