Alphabetical reference |
|
| Commands and Queries Reference | |
TOSET | set the remote communication time out period. |
| ||
| Syntax | TOSET <int> |
| |
| Parameters | the amount of time to wait between remote | ||
|
| communication events before a time out event is | ||
|
| declared. The allowed values are in the range 1 to | ||
|
| 255 and the time units are seconds. A value of “0” | ||
|
| will not change the programmed time out period but | ||
|
| will | cause the feature to | be disabled (same as |
|
| “TOEN 0”). |
| |
| Category | System | Type: Sequential | |
TOSET? | return the programmed time out period of the remote communication | |||
| time out feature. |
|
| |
| Syntax | TOSET? |
| |
| Parameters | none |
| |
| Category | System | Type: Sequential | |
TRIG | program the | Power | Module’s reaction to a | software or hardware |
| trigger. |
|
|
|
| Syntax | TRIG <ch>,<int> |
| |
| Parameters | the number of the Power Module to be programmed. | ||
|
| the action to be performed by the Power Module | ||
|
| when a trigger is received: |
| |
|
| 0 = set output to values programmed while armed. | ||
|
| 1 = toggle output on/off. |
| |
|
| 2 = initiate ramp to VSET programmed while armed. | ||
|
| 3 = initiate ramp to ISET programmed while armed. | ||
|
| 4 = output on. |
| |
|
| 5 = output off. |
| |
|
| 6 = no operation. |
| |
|
| 7 = |
| |
| Category | Trigger and Sync | Type: Sequential | |
TRIG? | return the current reaction to trigger for the Power Module. Result is a | |||
| decimal number in the range 0 to 7. |
| ||
| Syntax | TRIG? <ch> |
| |
| Parameters | the number of the channel to be queried. | ||
| Category | Trigger and Sync | Type: Sequential | |
TRIGER | send a global trigger (to all Power Modules). |
| ||
| Syntax | TRIGER |
| |
| Parameters | none |
| |
| Category | Trigger and Sync | Type: Overlapped | |
64 | XMP 2600 Programming Manual rev. 1.1 |
