Xerox 2045e Troubleshooting, Error & Status Messages on the Display Panel, Status messages

4. Troubleshooting

Error & Status Messages on the Display Panel

This section describes the principal messages that appear on the panel display. If a message not described here appears, act according to the message.

Reference

Before turning the main power off, see ‘Turning On the Power’, General Set- tings Guide.

❖ Status messages

Message	Status
Hex Dump Mode	In Hex Dump mode, the machine receives data in hexadecimal
	format. Turn off the machine after printing, and then turn back
	on.
Offline	The machine is offline. To start printing, switch the machine
	online by pressing [Offline] on the display panel.
Please wait.	The machine is preparing the development unit. Wait a while.
Printing...	The machine is printing. Wait a while.
Ready	This is the default ready message. The machine is ready for
	use. No action is required.
Resetting job...	The machine is resetting the print job. Wait until “Ready” ap-
	pears on the display panel.
Waiting...	The machine is waiting for the next data to print. Wait a while.

❖ Alert messages

Messages/Second messages	Causes	Solutions
Cannot connect with the	The IEEE 802.11b card may	Turn off the main power
wireless card.	have come off, or an error may	switch, and check the card is
	have occurred in the IEEE	installed correctly. If the mes-
	802.11b card.	sage appears again, contact
		your sales or service repre-
		sentative.
Close duplex unit cover.	The cover of the duplex unit is	Close the cover of the duplex
	open.	unit.
Collate has been cancelled.	The collate print function has	Turn off the main power
	been canceled.	switch, and back on again. If
		the message appears again,
		contact your sales or service
		representative.

23