Yamaha RX-Z11 104 En, ■Parametric EQ (Parametric equalizer)

Graphical user interface (GUI) menu

■Parametric EQ (Parametric equalizer)

Use this feature to adjust the parametric equalizer of each speaker.

Dynamic Range	Subwoofer L
S-Wave Control	Subwoofer R
Parametric EQ	Test Tone
Tone Control	PEQ Data Copy
Lipsync	PEQ Select

PEQ Data Copy (Parametric equalizer data copy)

Use this feature to copy the result data of the automatic setup to the manual configuration area. You can select the parametric equalizer type applied to the copied result data of the automatic setup. See page 50 for the descriptions of each parametric equalizer type.

ChoiceDescriptions

Flat → Manual Copies the result of the automatic setup that the “Flat” type parametric equalizer is applied to.

Front → Manual Manual Copies the result of the automatic setup that the “Front” type parametric equalizer is applied to.

Natural → Manual Copies the result of the automatic setup that the “Natural” type parametric equalizer is applied to.

PEQ Select (Parametric equalizer type select)

Use this feature to select the parametric equalizer type that applied to the results of the automatic setup. See page 50 for the descriptions of each parametric equalizer type.

Choice	Descriptions
Manual	Applies the manually configured parametric equalizer in
	“Manual Setup”.
Flat	Applies the “Flat” type parametric equalizer.
Front	Applies the “Front” type parametric equalizer.
Natural	Applies the “Natural” type parametric equalizer.
Through	Does not use the parametric equalizer.

Notes

•When you carry out the automatic setup, this unit automatically set “PEQ Select” to “Natural”.

•“Speaker Level” settings (see page 102) also changes corresponding to the setting of “PEQ Select”.

•This unit does not change the configurations of “Manual” even if you perform the automatic setup.

Manual parametric equalizer configuration of each speaker

Use this feature to adjust the tonal quality of each speaker. You can copy the results of the automatic setup for the base of the manual configuration by using “PEQ Data Copy”. Set “PEQ Select” to “Manual” in advanced.

1Press 9k / n / l / h to select “Test Tone” or the speaker you want to adjust.

Choice	Adjusted speaker
Front L	Front left speaker
Front R	Front right speaker
Center	Center speaker
Surround L	Surround left speaker
Surround R	Surround right speaker
Surround Back L	Surround back left speaker
Surround Back R	Surround back right speaker
Front Presence L	Front presence left speaker
Front Presence R	Front presence right speaker
Rear Presence L	Rear presence left speaker
Rear Presence R	Rear presence right speaker
Subwoofer L	Subwoofer left
Subwoofer R	Subwoofer right

Test Tone

Use this feature to select whether to turn on or off the test tone output while you are adjusting the tonal quality of each speaker.

Choice	Functions
On	Outputs the test tone.
Off	Does not output the test tone.

2Press 9h to access the settings window.

PEQ Data Copy	PARAM	RESET
PEQ Select	EDIT	EXIT
Front L	Band/Gain
Front R
Center

3Press 9k / n / l / h to select “PARAM” and then press 9ENTER to select a parameter from “Band”

(band), “Freq.” (frequency) or “Q” (Q factor).

y

You can adjust “Gain” (gain) with any parameter.

104 En