|
| Troubleshooting | |
During Auto Setup |
|
|
|
|
|
|
|
Error message | Cause | Remedy | See page |
Front L/R channel signals are not detected. | Check the front L/R speaker connections. | ||
|
|
|
|
A surround channel signal is not detected. | Check the surround speaker connections. | ||
|
|
|
|
A front presence channel signal is not detected. | Check the front presence speaker connections. | ||
|
|
|
|
E04:SBR → SBL | Only right surround back channel signal is | Connect the surround back speaker to the | |
| detected. |
| |
|
| only have one surround back speaker. |
|
|
|
|
|
Background noise is too loud. | Try running “Auto Setup” in a quiet environment. | — | |
|
|
|
|
|
| Turn off noisy electric equipment like air | — |
|
| conditioners or move them away from the |
|
|
| optimizer microphone. |
|
|
|
|
|
Surround back speakers are connected, though | Connect surround speakers when you use surround | ||
| surround L/R speakers are not. | back speakers. |
|
|
|
|
|
The optimizer microphone was unplugged during | Connect the supplied optimizer microphone to the | ||
| the “Auto Setup” procedure. | OPTIMIZER MIC jack on the front panel. |
|
|
|
|
|
A rear presence channel signal is not detected. | Check the rear presence speaker connections. | ||
|
|
|
|
The “Auto Setup” procedure was cancelled due to | Run “Auto Setup” again. | ||
| user activity. |
|
|
|
|
|
|
An internal error occurred. | Run “Auto Setup” again. | ||
|
|
|
|
After Auto Setup |
|
|
|
|
|
|
|
Warning message | Cause | Remedy | See page |
Speaker polarity is not correct. This message may | Check the speaker connections for proper polarity | ||
| appear depending on the speakers even when the | (+ or |
|
| speakers are connected correctly. |
|
|
|
|
|
|
The distance between the speaker and the listening | Bring the speaker closer to the listening position. | — | |
| position is over 24 m (80 ft). |
|
|
|
|
|
|
The difference of volume level among speakers is | Readjust the speaker installation so that all | — | |
| excessive. | speakers are set in locations with similar |
|
|
| conditions. |
|
|
|
|
|
|
| Check the speaker connections. | |
|
|
|
|
|
| Use speakers of similar quality. | — |
|
|
|
|
|
| Adjust the output volume of the subwoofer. | |
|
|
|
|
The result of the wiring check of “Auto Setup” is | Use “Speaker Set” in “Manual Setup” to adjust the | ||
| different from “Speaker Set” in “Manual Setup”. | speaker settings manually. |
|
|
|
|
|
| “Wiring” check procedure is skipped. | Select “Wiring” in “Setup Menu”. | |
|
|
|
|
Notes
•If the “ERROR” or “WARNING” screens appears, check the cause of the problem, then run “Auto Setup” again.
•If warning “W2” or “W3” appears, the adjustment are made, however the adjustments may not be optimal.
•Depending on the speakers, warning “W1” may appears even if the speakers connections are correct.
•If error “E10” occurs repeatedly, please contact a qualified Yamaha service center.
Information | Additional |
|
|