Before performing the following operations, set the operation mode selector on the remote control to FSOURCE and then press
3TUNER.
Manual preset tuningUse this feature to store the desired FM and AM stations manually. You can also store up to 40 stations (A1 to E8: 8 preset station numbers in each of the 5 preset station groups) manually.
1Tune into the desired station.
See pages 68 and 69 for tuning instructions.
2Press JMEMORY (or 0MEMORY).
The MEMORY indicator flashes in the front panel display for approximately 10 seconds.
MEMORY
Flashes
3Press MPROGRAM (or
The selected preset station group letter appears. Check that the colon (:) appears in the front panel display.
| A 1 : F M 8 8 . 9 M H z | MEMORY |
| ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
| Colon (:) | Flashes | |||||
Preset |
|
|
|
|
|
|
| ||
station group |
|
|
| ||||||
4Rotate MPROGRAM (or press 9PRESET/CH k / n repeatedly) to select a preset station number (1 to 8) while the MEMORY indicator is flashing.
•Rotate MPROGRAM rightward to select a higher preset station number.
•Rotate MPROGRAM leftward to select a lower preset station number.
A 1 : F M 8 8 . 9 M H z | MEMORY |
| |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Preset station |
| number |
|
| |||
| Flashes | ||||||
FM/AM tuning
5Press JMEMORY (or 0MEMORY) while the MEMORY indicator is flashing.
The station band and frequency appear in the front panel display with the preset station group and number you have selected. The MEMORY indicator disappears from the front panel display.
A 1 : F M 8 8 . 9 M H z
The displayed station has been stored as A1.
Notes
•Any stored station data existing under a preset station number is cleared when you store a new station under the same preset station number.
•The reception mode (stereo or monaural) is stored along with the station frequency.
Exchanging preset stationsYou can exchange the assignments of two preset stations with each other. The example below describes the procedure to exchange preset station “E1” with “A5”.
1Select preset station “E1” using MPROGRAM on the front panel.
See “Selecting preset stations” on page 70.
2Press and hold LEDIT for more than 3 seconds.
The MEMORY indicator flashes in the front panel display.
E 1 : F M 8 8 . | 9 M H z | MEMORY |
| |
E D I T |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| |
|
| Flashes | ||
3Select preset station “A5” using MPROGRAM.
The MEMORY indicator flash in the front panel display. See “Selecting preset stations” on page 70.
A 5 : F M 8 8 . | 9 M H z | MEMORY |
| |
E D I T |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| |
|
| Flashes | ||
4Press LEDIT again.
A 5 : F M | 8 8 . 9 M H z |
E | 1 - A 5 |
|
|
Operation | Source Internal |
|
|