3Press IMENU on the remote control.
Following menu screen appears in the video monitor.
4Press 9k to select “Setup Menu” and then 9h.
The list of the measurements in the automatic setup appears in the screen.
5Press 9k repeatedly to select “Multi Measure”.
6Press 9h and then 9k / n repeatedly to set the number of the listening positions you want to make the measurement at.
Choices: 1, 2, 3, 4, 5, 6, 7, 8
|
| |
| ||
✓ | ||
| ||
|
| |
| ||
✓ | ||
|
✓ Distance
Optimizing the speaker setting for your listening room (YPAO)
11Press 9ENTER to start the measurement at the next listening position.
y
To skip the measurements at the remaining listening positions, press
9n.
12Repeat steps 10 and 11 until the measurements at all listening points are completed.
13Once following display appears in the video monitor, place the supplied microphone base at the listening point you want to be seated most frequently as follows.
Make sure that the arrow mark on the microphone base points the center speaker or between the front left and right speakers.
| 1 | |
|
| |
3 | 2 | |
Preparation
7Press 9l to return to the previous menu level and then press 9n repeatedly to select “Angle”.
8Make sure that a check mark appears in the check box of “Angle”.
If the check mark does not appears, press 9ENTER to select the check box.
9Once you have finished the settings, press 9l to return to the previous menu level and then press 9n to select “Start”.
This unit starts the measurement procedure. See page 48 for details.
10Once this unit pauses the automatic measurement procedure and then “Put the microphone at 2nd listening position” appears in the display, move the optimizer microphone to the listening position 2.
| ||
| ||
| ||
| ||
| ||
| ||
| Skip: | |
| ||
|
Microphone base
Note
For the accurate measurements of the speaker angles, we strongly recommend that you use a tripod (etc.) to affix the microphone base at the same height as your ears would be when you are seated in your listening position. You can use the attached screw of a tripod (etc.) to fix the microphone base to the tripod (etc.).
14Place the optimizer microphone to the “(1)” position on the microphone base.