Use this feature to optimize the sound of this unit to the listening room quickly.
1Connect the supplied optimizer microphone to the OPTIMIZER MIC jack on the front panel.
“MIC ON” appears in the front panel display.
|
|
| STRAIGHT | TUNING MODE | MEMORY | BAND | PRESET/TUNING | PROGRAM | MENU |
|
| SPEAKERS |
|
|
|
| EDIT |
|
|
|
|
|
|
|
|
|
|
| |
AUDIO SELECT | A | B | EFFECT | DISPLAY | MAN'L/AUTO |
| SEARCH MODE |
|
|
|
|
|
| ZONE ON/OFF |
| ZONE | REC OUT/ |
| TONE CONTROL |
|
|
|
| CONTROLS | ZONE 2 |
| |||
|
|
| MULTI |
|
|
|
|
|
|
|
|
| ZONE |
|
|
|
|
|
|
|
|
| ZONE 2 | ZONE 3 | ZONE 4 |
|
| PUSH ENTER |
|
SILENT CINEMA | YPAO | S VIDEO | VIDEO | L AUDIO | R | OPTICAL | HDMI IN | USB | |
|
| OPTIMIZER |
|
|
|
|
|
|
|
PHONES | MIC |
|
| VIDEO AUX |
|
|
| ||
A U T O S E T U P
E N T E R T O S T A R T
Note
If “GUI” appears in the front panel display as follows, the menu screen (GUI) is displayed in the video monitor and you cannot proceed the quick automatic setup. In such a case, press NMENU to turn off the GUI or use the basic automatic setup procedure (see page 48).
G U I
R X - Z 1 1
2Place the optimizer microphone at your normal listening position on a flat level surface with the
Optimizer microphone
y
It is recommended that you use a tripod (etc.) to affix the optimizer microphone at the same height as your ears would be when you are seated in your listening position. You can use the attached screw of a tripod (etc.) to fix the optimizer microphone to the tripod (etc.).
Optimizing the speaker setting for your listening room (YPAO)
Before proceeding next operation
Once you perform the next operation, this unit starts the automatic setup procedure immediately. For more accurate measurements, we recommend that you move to the wall where speakers are not around.
3Press MPROGRAM on the front panel to start the measurements.
This unit starts the measurements immediately. Loud test tones are output from each speaker during the automatic setup procedure. During the setup procedure, following messages appear in the front panel display.
A U T O S E T U P
P R E P A R I N G
A U T O S E T U P
M E A S U R I N G
A U T O S E T U P
A N A L I Z I N G
y
To cancel the automatic setup procedure, rotate EVOLUME.
Notes
•During the automatic setup procedure, do not perform any operation on this unit.
•Keep quiet when you leave the room. The necessary time for the automatic setup procedure may differ depending on the environment of the listening room and connected speakers (from 30 seconds to 5 minutes).
4Once this unit completes all measurements and adjustments successfully, following message appears in the front panel display.
C O M P L E T E D
P L S U N P L U G M I C
If error or warning message appears...
Error message appears in the front panel display. See the “Auto Setup” section in “Troubleshooting” on page 152 for a complete list of error messages and proper remedies.
E R R O R : E - 0 1
P R E S S E N T E R
y
You can check the detailed results of the measurements by using the video monitor. See page 49 for details.
Preparation